Specifies the method for determining the ability of wire of diameter or thickness 0,3 to 10 mm inclusive to undergo plastic deformation during simple torsion. The test consists of twisting a test piece of wire around its own axis in one direction.
n 17 November 1992 a radiological accident occurred at an electron accelerator facility in Hanoi, Viet Nam. An individual entered the irradiation room without the operators' knowledge and unwittingly exposed his hands to the X ray beam. His hands were seriously injured and one hand had to be amputated. The report details the circumstances of the accident, its medical consequences and the govern…
The detection of flaws in an item submitted to X- or gamma-radiographic examination depends on the particularities of the technique employed. This part of ISO 1106 specifies general techniques of weld radiography with the object of enabling satisfactory results to be obtained economically. The techniques are based on generally accepted practice and the fundamental theory of the subject.
This part of ISO 8529 is closely related to two other standards concerning the calibration of dosimeters and dose-rate meters for neutron radiation. The first standard, ISO 8529-1 (in preparation), specifies the reference neutron radiations, in the energy range from thermal up to 20 MeV, and their production methods. The second standard, ISO 8529-2 (in preparation), describes fundamentals relat…
This document specifies additional procedures and data for the calibration of dosemeters and doserate meters used for individual and area monitoring in radiation protection. The general procedure for the calibration and the determination of the response of radiation protection dose(rate)meters is described in ISO 29661 and is followed as far as possible. For this purpose, the photon reference r…
-
Stabilisation/Solidification Treatment and Remediation - Advances in S/S for Waste and Contaminated Land contains 39 papers, summaries of the four keynote lectures and the seven State of Practice reports presented at the International Conference organized by the EPSRC-funded network STARNET (Stabilisation/solidification treatment and remediation). A wide range of topics relating to the stabiliz…
This book contain of seven section: Section I. Introduction; Section II. General provisions; Section III. Activity and fissile material limits; Section IV. Preparation, requirements and controls for shipment and for storage in transit; Section V. Requirements for radioactive materials and for packagings and packages; Section VI. Test procedures; and Section VII. Approval and administrative requ…
This book consist of chapter I. Introduction; 2. The Photographic Process, a review of terms and concepts; 3. Application of the photocraphic technique to personnel monitoring; 4. Requirements for setting up a photographic personnel monitoring service; and 5. Examples of photographic personnel monitoring procedure. (Jml)
This first revision of the Basic Safety Standards was approved by the IAEA board of Governors in September 1965. It was prepared with the assistance of a panel of experts chaired by Prof. L. Bugnard, Director of the French Institut National d'Hygiene, and attended by representatives of several international organizations. (Jml)